Labounty MSD 3000 - Page 35

MSD Legend Series Operation & Maintenance Manual | 35
13. Install each piercing tip into the opposite blade seat
from which it was removed. Torque bolts to values
show in “Inspect / Torque Bolts” on page 25.
14. Measure the clearance between the tip blades.
Ensure the clearance is within the specication found
in the table below. If there is no clearance, clean the
blade and seat as shown in step 11
15. Once installed, shim all cutting blades as shown in
“Measuring & Shimming Blade Gaps” on page 28.
Then torque the blades as shown in “Inspect / Torque
Bolts” on page 25.
Blade Clearance
Piercing Tip Clearance Table
Model Clearance
MSD 2250
0.001” - 0.018”
(.0254 - .457 mm)
MSD 2500
MSD 3000