Lacunza ITACA Series - Opening the Door; Opening Using the Guillotine System

INSTRUCTIONS OF USE 23
3.
Figure No.28 - Dismantling the lower Itaca
deflector
Soot falling from the flue may build up
on the deflector.
Then remove the second deflector by
drawing it forwards and allowing it to drop
at the rear.
Figure No.29 - Removing the middle deflector
on the Itaca
Soot falling from the flue may build up
on the deflector.
3.8. Opening the door
The door can be opened in 2 ways:
3.8.1. Opening using the guillotine
system:
This system, in which the door opens
vertically, is the usual way to open and
close the firebox in order to load and
rearrange the firewood when the appliance
is in normal use. Use the glove supplied in
order to move the door using the handle in
order to prevent possible burns to the
hands. When you open the door, apply
slight upward pressure to free the sealing
cord from the front. When you have lifted
the door a couple of centimetres, you
should notice that it moves more freely
than at first. To close the door, apply slight
downward pressure when it is at its lowest
position so that the cord completely seals
the firebox from the outside.