laerdal SimPad - Run Automatic Mode

8
9
English
RUN AUTOMATIC MODE
When running a scenario in Automatic Mode, the only task required by the instructor is to
log the participant’s actions. These events logged, as well as the events detected by the patient
simulator, will drive the scenario forward. All events are registered in the log for post-event
debrieng and analysis.
Start by selecting a scenario from one of the scenario folders.
Submit session
information.
Press OK
when ready.
Press START to enter
session information.
Folder
of scenarios.
Tap to open.
Select an
automatic
scenario.
Scenario description is
divided into sections.
Tap to open.