Lainox Naboo boosted - Points to Remember When Making the Electrical Connection

90037350rev01
- 28 -
7.1 • As all ovens of the series are fitted with
an alternating fan motor (clockwise and
anticlockwise rotation), there is no need
for the fan to rotate in any particular
direction. Simply verify, when
commissioning the appliance, that
the fan is balanced and rotates freely.
Warning: the 20 x GN 1/1 and 20 x GN 2/1
models are equipped with two motors.
7.2 • When making the electrical connection you
need to take care that the neutral pin of the
terminal block corresponds to the neutral
wire of the supply line. If this connection is
not made correctly, the burners will not be
able to operate.
This error is signalled by the electronic
circuit board.
7.3 • Check also that the neutral registers
zero potential when tested. If not, the
fault already described in point three of
this section will occur. In this eventuality,
consult the installer of the building’s
electrical system.
7.4 • Ethernet connection
Use at least a category 5 network cable
for the data connection. The Ethernet
connection is located on the lower right-
hand side of the appliance.
7 • POINTS TO REMEMBER WHEN MAKING THE ELECTRICAL CONNECTION
6 • ELECTRICAL CONNECTIONS AND EQUIPOTENTIAL BONDING
6.11 Countertop appliances designed for a
standard AC 230V power supply for gas
ovens and 3NAC 400V power supply for
electric ovens, are supplied with a power cord
without plug.
The multicore cable is made up of the
following coloured wires:
3N AC 400V power supply:
Active L1 BROWN
Active L2 BLACK
Active L3 GREY
Neutral N BLUE
EARTH YELLOW-GREEN
3 AC 400V or 3 AC 230V power supply:
Active L1 BROWN
ActiveL2 BLACK
ActiveL3 GREY
EARTH YELLOW-GREEN
AC 230V power supply
ActiveL1 BROWN
Neutral N BLUE
EARTH YELLOW-GREEN
6.12 • Appliances which differ from those described
above are supplied without a power cable.