90037350rev01
- 47 -
Do not install the appliance in areas with
a temperature less than 5°C.
14.1 • Check the appliance and the entire
installation straight after connecting.
Check in particular:
• there are no traces of the protective film on
the outside walls and the oven is empty;
• all the vents are clear;
• the connections are made as required and
instructed in this handbook;
• all the safety requirements of the current
standards, laws and directives are met;
• there is no leakage from the gas and water
connections;
• water drainage and flue gas extraction are
clear.
• Apply the adhesive with the warning signal
against the scalding danger at a height
from the ground of 1.6m.
14.2 • BEFORE START-UP
Danger of burning due to steam.
Steam is produced during operation or
cleaning of the appliance. If the cooking
chamber door is opened, there is a
possibility of burns due to steam.
Open the cooking chamber door carefully
and leave it ajar for a few seconds so that
the steam can escape upwards.
Make sure that there is no-one in the area
where the steam is escaping.
14.3 • Now proceed to light the oven as directed
in the user manual, checking the smooth
ignition of the burner.
14.4 • You should moreover check that the
silicone joints and sleeves of the water
circuit (oven vent, oven outlet, drip tray) do
not leak.
14.5 • Carefully refit the right-hand side that was
removed for the above work.
14.6 • For additional certainty that the appliance
is operating correctly, carry out a
volumetric measurement of the quantity
of gas consumed. The meter will show
how much gas has been consumed over
a given period of time, and this value can
be checked against the values given in
Table 5 of the “Tecnical gas data” booklet.
14.7 • The test report must be completed in all its
parts, registered on the “service-planner”
technical portal and submitted to the
Client, who must sign it for acceptance.
This operation automatically starts the
oven warranty period.
14.8 • ATTENTION: Upon installation, we
recommend updated the oven software to
the latest version.
14 •COMMISSIONING AND TESTING
1600 mm (63 inch)
To Next Page
Loading...
