8
90035620rev01
GENERAL WARNINGS
• If technical support is required, then all the information on
the data plate must be provided, together with detailed
information about the defect, so that the support service
can understand the problem.
• The power supply to the oven must have a circuit-breaker
master switch with a minimum opening distance between
the contacts of at least 3 mm per pole.
• The oven must be included in an equipotential system. This
connection is carried out by attaching a wire with a nominal
section up to 10 mm
2
to the relevant terminal, located on the
rear of the oven and marked with the international symbol
IEC60417 – 5021�
The connection is made between all the adjacent appliances
located in the room and the earthing system for the building.
• This manual is also available in electronic format.
Contact your support service.
To Next Page
Loading...
Need help?
General