Landmann 43100 - Main burner Lighting Instructions

22
Main burner Lighting Instructions
Prior to the first use, it is important to clean your grill
with heat. This will clean the internal parts by burning
off any residue and odor from the manufacturing
process. To perform this cleaning, operate the grill for
approximately 15-20 minutes at the highest heat
setting with the lid closed.
IMPORTANT
Please read these instructions before attempting to
light the grill.
Failure to open the lid before igniting
may result in an explosive flare-up,
which can cause serious bodily
injury or death.
DO NOT lean over the open grill
when lighting.
1.
Turn all gas control knobs to the OFF position.
2. Turn on gas valve from gas source.
3. Lid MUST be open when lighting.
4.
Push in and slowly turn the desired control knob to
HI. If the burner does not light turn the knob OFF
and then repeat.
5.
If the burner will not light within 3 attempts, use
the match lighting instructions shown on this page.
6.
Always wait 5 minutes before attempting to relight
burners.
Failure to follow the five-minute
waiting period may result in an
explosive flare-up, which can cause
serious bodily injury or death.
7.
To extinguish the burner, push in the control
knob and turn clockwise to the OFF position.
Match Lighting
Note: Match lighting tool is typically located inside an access
door.
1.
Turn all gas control knobs to the OFF position.
2. Turn on gas valve from gas source.
3. Lid MUST be open when lighting.
4. Remove the match lighting tool and stick a match
into the end of the tool.
5. Light the match.
6. Once lit, guide the lit match under the grate.
7.
Push in and turn the control knob to HI for the
burner closest to the light match. The burner should
light immediately.
8. Adjust burner control knob to the desired cooking
temperature.