EasyManuals Logo

Lantronix SLC 8048 User Manual

Lantronix SLC 8048
425 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #393 background imageLoading...
Page #393 background image
15: Command Reference
SLCâ„¢ 8000 Advanced Console Manager User Guide 393
Routing Commands
set routing
Syntax
set routing [parameters]
Parameters
rip <enable|disable>
route <1-64> ipaddr <IP Address> mask <Netmask> gateway <IP Address>
static <enable|disable>
version <1|2|both>
Description
Configures static or dynamic routing.
To delete a static route, set the IP address, mask, and gateway parameters to 0.0.0.0.
show routing
Syntax
show routing [resolveip <enable|disable>] [email <Email Address>]
Description
Sets the routing table to display IP addresses (disable) or the corresponding host names (enable).
You can optionally email the displayed information.
RPM Commands
set rpm add
Syntax
set rpm add <RPM Name>
Description
Adds an RPM to be managed (prompts will guide selection of RPM vendor and model).
set RPM command
Syntax
set rpm command <RPM Id or Name>
outlet <all|Outlet # or List> state <on|off|cyclepower>

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lantronix SLC 8048 and is the answer not in the manual?

Lantronix SLC 8048 Specifications

General IconGeneral
BrandLantronix
ModelSLC 8048
CategorySwitch
LanguageEnglish

Related product manuals