EasyManuals Logo

Lantronix UBOX 2100 User Manual

Lantronix UBOX 2100
79 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #35 background imageLoading...
Page #35 background image
5: Changing the UBox's Settings
UBox User Guide 35
Subnet Mask
A subnet mask defines the number of bits taken from the
IP address that are assigned for the host part. Enter the
subnet mask as xxx.xxx.xxx.xxx.
Example: 255.255.255.0
Gateway
The gateway address, or router, allows communication to
other LAN segments. The gateway address should be the
IP address of the router connected to the same LAN
segment as the unit. The gateway address must be within
the local network. Enter the gateway as xxx.xxx.xxx.xxx.
Example: 192.168.20.100.
Note: If there is no gateway on the network, use the same
IP address as the UBox or the IP address of your PC.
UDP Port and
TCP Port
These fields allow you to specify which port numbers on
which the UBox communicates. This communication
happens between the UBox hardware and software. By
default, these ports are set to 10010.
UDP Port: Change this setting to change the UDP port
number on which the UBox broadcasts. Other computers
configured to use this UDP port number will be able to see
this UBox. This setting is useful if you wish to limit the
number of people connecting to a particular UBox or if you
want to hide a UBox from other users on your network.
If you change the UBox's UDP port number, you must tell
the UBox software to “listen” to the new port. To do this,
change the local UDP port number. (See Updating Server
Access Settings on page 46.)
TCP Port: Change this setting to change the TCP port
that the UBox uses to transmit and receive USB data.
If you change the UBox's TCP port number, you must tell
the UBox software to “listen” to the new port. To do this,
change the local TCP port number. (See Updating Server
Access Settings on page 46.)
Note: Most users will not need to change the UBox's UDP
and TCP ports. However, certain firewalls may block traffic
to the default UDP and TCP ports. In these instances, you
can either change the port numbers or configure your
firewall to allow connections using UBox's configured UDP
and TCP ports.

Table of Contents

Other manuals for Lantronix UBOX 2100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lantronix UBOX 2100 and is the answer not in the manual?

Lantronix UBOX 2100 Specifications

General IconGeneral
BrandLantronix
ModelUBOX 2100
CategoryComputer Accessories
LanguageEnglish