SETTINGS - 11
SET-UP
WARNING
ALWAYS CHECK THE PROPER
TIGHTENING OF YOUR
WHEELS BEFORE EACH RIDE.
WARNING: The sidewalls of the rim, like the brake pads, are subject to wear. Therefore, it is essential to
replace the rim when it is worn. A wear indicator on the rim allows to visualize its being of fatigue. If you
do not replace the rim in time, it may burst when rolling which would inevitably cause your fall.
3 RECOMMENDATIONS
3.1 - TORQUE SPECIFICATIONS
in absence of any other indication on the concerned part please use the following torque.
- Classic stem = 20 Nm
- Handlebars on a classic stem = 25 Nm
- Threadless headset = 4-5 Nm on the pivot
and 4-5 Nm on the handlebars
- Brake cables = 6-8 Nm
- Brake pads = 5-7 Nm
- Brake levers = 6-8 Nm
3.2 - SUSPENSION FORKS
Your suspension fork requires specific, precise maintenance that may vary depending on the fork. It is
imperative that you read the manufacturer’s notice that is delivered with your bike. Due to the impact and
the shocks that suspension forks absorb, it is important to clean the stanchions and inspect the joints after
each use. Please refer to the manufacturer’s notice for information regarding how often you should change
or add oil. Only a specialist who has the proper tools should perform these operations.
III - SPECIFIC MODELS
1 - CARBON MODELS
Our carbon frames are the result of long hours of research and development, and owning one requires
certain maintenance procedures that will prolong the life of your bike and assure optimal performance.
- Pay close attention to your bike, listening for any strange noises and visually inspecting the frame
and parts on a regular basis.
- Perform regular tune-ups:
• Periodically visit your authorized Lapierre dealer so he can inspect your bike.
• In case of any serious accidents, have your bike examined by an authorized Lapierre dealer before riding it again.
• Avoid using grease on your seat tube as certain ones can be harmful to the resin and deteriorate it.
• During winter rides, it is absolutely necessary to wash your bike after each ride in order to avoid damaging
the frame from the salt.
II - SETTINGS
ENGLISH
- Rear derailleur = 8-10 Nm
- Front derailleur = 5-6 Nm
- Shifters = 5 Nm
- Wheelnuts = 20 Nm
- Saddle clamp = 10 Nm
To Next Page
Loading...
