EasyManua.ls Logo

Larson Davis Spartan 821 - Chapter 3 Meter Settings

Larson Davis Spartan 821
129 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Spartan 821/721 Manual 23
Chapter 3
Meter Settings
The 721/821 makes measurements based on the values selected from the
Settings screen. Prior to beginning a measurement, configure the settings
suited to your application, as shown in this section.
TAKE NOTE The settings for making a measurement are organized
in cards on the Settings screen. To open or close a card tap the
golden down and up arrows.
Within a card, tap inside a field to view and select from available
values near the bottom of the screen. Tap outside the selection
box to close it.
When modifying text fields, a keyboard will popup. Each time you
modify a text field, you will have to retype the desired text. For
supported languages, to enter text using characters not in the
Latin alphabet, use G4 or LD Atlas.
Settings are not available to edit while running a measurement. If
you need to edit settings with a measurement in progress, tap
Stop +Store . Or to clear the current measurement data
without saving, tap Tools
Reset. When “Store on Stop” is
enabled, simply stop the measurement. You may then edit
settings and make a new measurement.
In this module:
3.1 Selecting Settings - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -24
3.2 Measurement Settings - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -24
3.3 System Settings - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -25
3.4 Exceedance Settings - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -27
3.5 Calibration Settings - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -28
3.6 Mode Control Settings - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -29
3.7 Dosimetry Settings - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -30
3.8 Ln Settings - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -32
3.9 Community Noise Settings - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -33
3.10 Markers Settings - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -34
3

Related product manuals