Pico rigging manual 2007.doc Page 12 of 28
2) At the back of the boom, use a small reef knot to tie on the clew hook with the
clew tie down rope.
3) Tie the clew outhaul line to the small fairlead on the outboard end of the boom.
With a bowline loop, then run through the eye of the clew hook, back round the
fairlead and up to the cleat on the boom.
4) Take the tail end of the clew outhaul line and pass it through the front fairlead
mounted on the boom. Thread through the small englefield clip and tie off with a
figure of eight knot.
To Next Page
Loading...
Need help?
General
