PARAMETERS SETTING
Pag.21
.
Functioning description
Func.
Num.
Volume of speaker
volume OFF00
LOW volume01
()02 factory setting - FSHIGH volume
01
Delay of MUTE function deactivation
not active active for 1 second active for 2 seconds,00 , 01 , 02
03 04 active for 3 seconds, active for 4 seconds
s ()05 FSactive for 5 second
07
10
Service display
00 (FS)not active
01 distance of nearest front obstacle [cm]
distance of nearest rear obstacle [cm]02
speed of vehicle (only with connected speed signal)03
learning of speed signal pulses04
version of ECU software05
power supply voltage [Volt]06
07 temperature of front unit [°C]
temperature of rear unit [°C]08
.
02
Type of unit
01 Front
()02 FSRear
Number of speed pulses
[impulses/m]01 - 99 FS= 03
(to this value is added value from parameter “09")
08
Fine adjustment of speed pulses
[impulses/m]0,0 - 0,9 FS= 0,0
09
All the parameters that the user can change, are listed in the following table and can be
modified using the buttons on the control unit.
WARNING! he irresponsible use of the settings can seriously limit the erformance of the t p
device.
18
Engine noise filter
00 OFF (FS)
ON01
To Next Page
Loading...
Need help?
Power
Operating Environment