LaserLine EPS4016 User Manual

REAR unit setting
41
Volume of rear LED indicator
volume OFF00
LOW volume01
()02 factory setting - FSHIGH volume for BZ model
42
Orientation of rear LED indication
()00 FSstandard
change left and right side01
43
Sensitivity of rear sensors
=-9 - +9 FS 00
45
Range of rear central sensors
Above 100cm display120 - 180 FS [cm] = 160
shows 10 - 12
46
Range of rear corner sensors
[cm] =45 - 90 FS 65
47
Range of rear central sensors STOP zone
[cm] = Above 100cm display30 - 120 FS 35
shows 10 - 12
40
Number of rear sensors connected
=02,03,04 FS 04
48
Range of rear corner sensors STOP zone
[cm] =30 - 90 FS 35
49
Suppression of rear protruding parts (spare wheel, hook)
( )00 FSfunction disabled
05,10,15,20,25,30 exclusion of the protruding parts from bumper in Cm
99 automatic exclusion of the protruding parts
!!! NOTE: change only if there is an overhang, eg. spare whell or other, increase
the value until the protrusion is no longer detected by the parking system.
52
Detection of very close obstacles
00 FS ()not active
active01
54
Acoustic signal timed of an obstacle in the R1, R2 and R3 areas
01 disabled function after 1 second
02, 03 - 10 timing, in step of operation sensors (seconds)
99 (FS)constant signalling of obstacles
55
Delay of rear sensors activation
()00 FSvehicle with manual transmission
vehicle with automatic transmission01
56
State of rear sensors after turn ON
(FS)00 all sensors active
everse gear command01 R for WIFI module (EPSKEY)
(operation with the connection of the yellow / Blue pin.7)
57
Dealay of rear sensors deactivation - time window
- [s] = (it’s necessary that control unit is00 0 FS3 00
powered through starting key)
60
State of rear sensors with connected trailer socket “pin 6" (negative command)
eactivated ( )00 FSsensors d
STOP zone of rear sensors is set according parameters 61, 6201
61
Range of rear central sensors STOP zone with bike carrier (pin 6 to ground)
[cm] =100 - 130 FS 100
62
Range of rear c sensors STOP zone with bike carrier (pin 6 to ground)orner
[cm] =100 - 130 FS 100
PARAMETERS SETTING
Pag.22

LaserLine EPS4016 Specifications

Power

supply voltage	10.8 - 3 V, 9 - 30 V
current consumption with active sensor	20 mA max

Operating Environment

range of service temperatures	-30/+0°C, -25/+70°C
frequency of ultrasound	40 KHz