Dirty sensors (mud, snow, ice, etc..)
Clean the sensor with a suitable cloth.
Sensors ed too low (see page 4)install
Use angled supports to tilt the sensors
upward. If there is still the problem select
the functions 4 and/or .3, 45,46 49
Rear side of sensors in contact with chassis
of vehicle
Separate sensors from the body of the
vehicle. They must not touch.
Detection of a towing hitch, spare wheel,
etc.. (See notes page )2
Select the n. function to solve the49
problem.
If irregular false obstacle indication occurs, one of the following problems:verify
None acoustic signal
- If the ACOUSTIC signalling are missing verify that the n.1 function is not stored as
“00” then verify the correct connection of the speaker or display (see pag. )8
PROBLEM SOLVING
Change of use of the control unit
- in case a control unit be used as a Rear or conversely, it is needed to change the
programmable function n.2 by choosing the use desired.
Pag.26
The Display shows the writ n “L ”ig O
- there is a low power supply to the unit.
The Display shows the writing “IF”
- There is a parameter setting through smartphone or PC with WIFI module
interface.
6
Extraction wires procedure
Extractor.
Front view
6
The Display shows the writing “LE”
- In case of connection of the Display Check that the wire in position n.4 is not
accidentally connected to ground.
To Next Page
Loading...
Need help?
Power
Operating Environment