13
- Never remove guards and other safety elements. They serve for your safety.
- Keep the given intervals for checks of bolted joints.
- Always after work clean all parts of the machine properly. Pay your attention
especially to any oil spots or fuel leakage. Clean any oily spots.
- Some parts of the machine can be hot while in operation. Avoid any settling of
flammable chipped materials on such parts or close to the hydraulic oil tank.
Stop working if such deposits exceed 1 mm.
- Any servicing can be done only if the machine was put out of operation, its
battery was disconnected and the cardan shaft was uncoupled. If the chipper is
still coupled to the three-point hitch, block the tractor (wheels) against
unwanted motion.
- Do not use petrol as a cleaning agent.
- Keep open fire away while filling the tank.
- Keep the machine beyond reach of open fire.
- Some parts of the machine run warm, such as hydraulic elements, belts and
pulleys. Do not touch them when the engine is still running or having been just
stopped.
- Do not let the engine running in high speed unreasonably.
- Do not start the machine in confined or ill-ventilated spaces.
- Combustion gases outgoing from a tractor are toxic!
- Do not use the machine under conditions of low visibility, especially at foggy
weather on public roads.
- Do not use the machine without prior reading this manual.
- Do not carry out any repairs that are specified for authorised services only.
- Do not carry out any repair where its
solution exceeds your experiences.
- It is strictly forbidden to work with the
chipping device damaged (out-of-
balance, vibrations while running).
- While servicing the chipping device, or in
the vicinity thereof, it should be always
blocked against unwilling motion (with
its safety pin inserted).
- Do not let the engine running in high
speed unreasonably.
- Do not start the machine in confined or
ill-ventilated spaces.
- Combustion gases outgoing from a tractor
are toxic!
To Next Page
Loading...