14
- Do not use the machine under conditions of low visibility, especially at foggy
weather on public roads.
- Do not use the machine without prior reading this manual.
- Do not carry out any repairs that are specified for authorised services only.
- Do not carry out any repair where its solution exceeds your experiences.
- It is strictly forbidden to work with the chipping device damaged (out-of-
balance, vibrations while running).
- While servicing the chipping device, or in the vicinity thereof, it should be
always blocked against unwilling motion (with its safety pin inserted).
-
Before transport on public roads:
At public road transport this machine must be lifted up in its transport
position, see instructions in this manual. First set also the machine in its
transport position, i.e. its loading chute and discharge duct folded down and
mechanically blocked against motion. Its side lights must be visible, not
covered, see fig.
Couple the chipper to a towing vehicle properly and check proper pin
coupling.
Before going on public roads, check up proper coupling and all locks in the
three-point hitch on the tractor.
Plug the machine lights in the tractor socket in rear and check up functions of
all lights.
If necessary, remove all mud, especially from tires, before coming to a public
road.
To Next Page
Loading...
