Laskomex MVC-8151 - Change of Tone, Call Volume and Number of Rings

- 8 -
Color monitor MVC-8151
call volume
call tone number of rings
Figure 3. User menu
User menu allows to:
• changethecalltone,
• changethecallvolume,
• setthenumberofrings,
• change the code of the code lock.
• register electronic keys.
To make changes a tenant must activate User menu. The help of the person in the apartment
isneededforthis.ToactivatetheUsermenu,performthefollowingsteps:
• Establish a connection with the apartment (only from the subordinate entry panel).
• Press the button KEY in the panel and still pressing it ask the person in the apartment to
presstheLOCKbuttoninthemonitorvetimes.
• Activation of the function is signaled by short beep in the monitor’s and the external pa-
nel’s loudspeaker as well as by message [OPC] displayed temporarily on the external pa-
nel`s display.
• Finish the conversation.
• Entertheapartmentnumber,thenpresstheKEYbuttonandenterthecodeofthecode
lock.Thedisplaywillshowthesymbolsdeningthecurrentstatusofindividualsettings.
In Figure 3 is shown the view of the display after switching on the User menu (view for the
default parameter values).
Change of tone, call volume and number of rings
• [1]Therstsignonthedisplaydenesthecalltone(0...7).Thecallsignalcanbechan-
ged by pressing the button marked with number [1].
• [2]Thesecondsignonthedisplaydenesvolumeofcallsignal(G–loud,N–incre-
asing,C–quiet,U–moderate).Theselectionofanincreasingsignalissensiblewhenthe
number of call signals is higher than 1. The volume is controlled with button [2].
• [3]Thethirdsignonthedisplaydenesthenumberofrings(1-8)–decideshow
long the door entry handset rings. Number of signals is controlled with button [3].