Laskomex MVC-8151 - Adjusting the Monitor; Operation of the Installation Procedure

- 14 -
Color monitor MVC-8151
• UTP+TERMINATOR – set the jumper in this position if the video signal is sent symme-
trically with the UTP cable and the monitor is located at the end of the video bus or is the
only line load. In this position the line is loaded with a 100R resistor.
Adjusting the monitor
The regulations available to the user are described in point 3 of this instruction.
In special cases you can adjust the audio signal using the following potentiometers available
on the back of the monitor:
• BAL1–correctionofthelevel(volume)ofthesignalcomingfromtheexternalpanel
• MIC1 – correction of the level (volume) of the signal coming out to the external panel
• BAL2–correctionofthelevel(volume)ofthesignalcomingfromtheoorpanel
• MIC2–correctionofthelevel(volume)ofthesignalcomingouttotheoorpanel
7. Operation of the „installation procedure” (requires activation in the CD-
2502/3100 system)
The procedure makes it easier to activate the door entry system. After starting the installa-
tion procedure you can set in the monitor the number of rings and the tone and volume of
the call (these are individual settings for each apartment number). Then the electronic mo-
dule automatically establishes connection with the handset or monitor in which the procedu-
rewasactivated,givingtheinstallertheabilitytocheckthedevice.
Turn on the preview from the CD door phone camera (one touch of the PREVIEW key) and
press the CONVERSATION button four times. The LED1 and LED2 light up at the same
time.
• Press the LOCK button once. The electronic module will start looking for the monitor
number in which the installation procedure was activated.
• Afterndingthemonitorthemonitornumberwillbedemonstrateusingtheacousticsi-
gnals(threedigitscorrespondingtothenumberofhundreds,tensandunits,similartopo-
int6).Alongerbreakmeansmovingtothenextnumber,alongersoundmeansthatthe
numberiszero.
• Select the call tone by pressing the LOCK button sequentially.
• Set the call volume in the door entry system using the CONVERSATION button (do not
confusewiththevolumesettingdirectlyinthemonitor,seepoint3).Therearethreevo-
lumelevels(loud,moderate,quiet)andaincreasingsignal(threeshortbeeps).
• Theselectedsettingsmustbeconrmedbylong-pressingtheCONVERSATIONbutton.
• After a moment the electronic module will call the monitor in which the installation pro-
cedure was activated. Press the CONVERSATION button to get a connection. The instal-