Laskomex MVC-8151 - Code Change of the Code Lock; Registering a New Electronic Key; Exit from User Menu

- 9 -
Color monitor MVC-8151
Code change of the code lock
This option can be blocked by installer.
• Activate User menu.
• Select[0]button.Therewillappearfourhorizontallines.
• Enter the current installer code. This step can be omitted if the installer decides so.
• Foramoment[NEU]and[CODE]messagesandthenfourhorizontallineswillappear.
• Enter the new code.
• Enter the new code again.
Registering a new electronic key
This option can be blocked by installer.
• Activate User menu.
• Select [8] button. The message [ADD] will appear on the display.
• Apply the electronic key to the reader.
• Message [NEU] means that the key has been stored in the memory with the assignment
totheapartment.Ifapreviouslyregisteredkeyhasbeenappliedtothereader,themessa-
ge [OLD] will appear on the display.
Exit from User menu
To exit from edition of User menu (not to exit from the whole procedure) in order to check
theoperationofsettingsandmakelaterpossiblechanges,presstheLOCKbutton.Thenthe-
re is a possibility to make a call.
Todenitivelyexitthewholeprocedurepressthe[C]button.Inthiscasere-enteringthe
menu requires repeating the entire procedure from the beginning.
After4minutesofinactivity,accesstotheUsermenuwillbeturnedoffautomatically.