EasyManuals Logo

Lauda Ecoline RE 206 User Manual

Default Icon
69 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
Startin
g
u
p
28
with key back to "setpoint selection". (level 0).
6.4.4.4 Starting of the programmer
From level 0 proceed as described under 6.4.4. When
PGM appears on the display, press the key on the left.
The display shows RUN, or
forward with key from EDIT resp. LOOP until RUN
appears, then
start the programme with the key on the left. The setpoint
level (level 0) is then on display.
During the start the current setpoint is accepted as the starting value.
If the programmer is activated:
level 0 shows PGM XXX.XX instead of SET XXX.XX (setpoint temperature), with
PGM flashing short
(short off, long on)
.
Setpoint can not be input with 0,01 °C resolution (only possible via RS 232
interface.)
General Rule: Programmer can also be loaded and operated via the RS 232
interface

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lauda Ecoline RE 206 and is the answer not in the manual?

Lauda Ecoline RE 206 Specifications

General IconGeneral
BrandLauda
ModelEcoline RE 206
CategoryThermostat
LanguageEnglish

Related product manuals