Lauda Ecoline RE 207 - Error Messages

Unit descri
p
tion
10
IN_ERR_00 fault diagnosis microcontroller 1
➀
IN_ERR_01 fault diagnosis microcontroller 2
➀
IN_MODE_00
(A015_IN_MODE_00
-->RS485)
0 = RS 232 + keyboard/ 1 = only RS 232 interface
(0 = RS 485 + keyboard/1 = only RS 485 interface)
RMP_IN_00_XX
(1...20)
Request to indicate the programme segments
(answer e.g 030.00_010.00 = 30.00 °C, 10 min)
RMP_IN_01 Request to indicate the current segment number, if
programmer is activated
RMP_IN_02 Request to indicate the number of programme running (pre-
set)
RMP_IN_03 Request to indicate the current programme running
➀ ➾
Section 6.5.5. Other error messages
3.7.5 Error messages
Message Explanation
ERR_2 incorrect input (e.g. buffer overflow)
ERR_3 incorrect command
ERR_5 syntax error on value
ERR_6 illegal value
ERR_28 receive – frame – error (e.g. stop bit missing)
ERR_29 Function blocked (at this time)
!
wait a few ms, then try again
ERR_30 Programmer, all segments are occupied
☞
RS 485 interface: Message ”A015_ERR_2”.