Starting up
10.08.99
YACE0060
23
6.4.3 Setting the setpoint resolution
and
2x
−
To set the setpoint resolution from level 0 press the key
combination on the left
−
move forward with the key from the PUMP-function.
−
The current bath temperature, RES and the current setpoint
resolution are indicated.
−
To alter the setting, press the key on the left.
−
Display flashes (approx. 4 s).
or
−
During this time, start to set the required resolution with one
of the two keys.
0,1 = 0,1 °C setpoint resolution, normal setting
0,01 = 0,01 °C setpoint resolution. During setpoint
input only S is indicated instead of SET.
−
Forward with the key to "parameter level" (RE 2xx only) or
to "programmer" (RE 3xx only) or
−
with key back to "PUMP“.
To Next Page
Loading...