Normally, cranking voltage value lower than 9.6V is regarded as abnormal,
higher than 9.6V is OK.
Test result of the tester includes actual cranking voltage and actual cranking
time.
When cranking test is abnormal, battery test result will also be displayed at the
same time.
This is for the convenience of the maintenance personnel to quickly know the
whole state of the starting system according to the data.
3.5 Charging System and Rectifier Diode Test
When enter the charging test, tester will prompt "Loaded testing"
Press OK key again to start the charging test.
NOTE: Do not shut down the engine during the test. All electrical appliance and
device are in OFF state. Turn on/off any electrical appliance in the vehicle
during the test will affect the accuracy of the test result.
To Next Page
Loading...
Need help?
General
