LAUNCH
X-431 PRO MINI User Manual
10
3 Network Setup
The tablet has built-in wireless module that can be used to get online. Once
you’re online, you can register the diagnostic App, activate the VCI device, surf
the Internet, get apps, send email, launch the remote diagnosis, and check for
software updates etc.
3.1 Connect to a WLAN network
1. On the home screen, tap Settings > WLAN.
2. Slide the switch to ON, the tablet starts searching for available wireless
networks.
3. Select a wireless network,
If the chosen network is open, the tablet will connect automatically;
If the selected network is encrypted, a network password will need to be
entered.
4. When “Connected” appears, it indicates the WLAN connection is complete.
Note: When WLAN is not required, this should be disabled to conserve battery
power.
Once it is connected successfully, tap the network from the list to view its name,
link speed, security type, IP address etc.
When this tool is in range, it will connect to the previously linked network
automatically.
3.2 Disconnect from a WLAN network
1. On the home screen, tap Settings > WLAN.
2. Tap the network with a
Connected
status, then tap “Disconnect”.
To Next Page
Loading...
Need help?
General
