LAVAZZA LB 2500 PLUS - DELTA TEMP; CHANGE PASSWORD; ENERGY SAVING; START PUMPS

28
EN
SETTINGS MENU
This value can be measured with the special colour
changing strips available on the market.
A value in a range between 5 and 50 French de-
grees can be input with buttons 4 and 5.
This value is set by default to 20 French degrees. If
a water softener lter is used, set a water hardness
value based on the hardness abatement capability
of the lter.
DELTA TEMP
By conrming “Delta Temp” with “Enter”, it is pos-
sible to change the working temperature of the
boiler so as to slightly increase or reduce the tem-
perature of the dispensed product. The value can
be increased or reduced by a range of ±4 °C using
buttons 4 and 5.
CHANGE PASSWORD
By conrming the “Change Password” item with
“Enter” the display will show:
PASSWORD
At this point you can input your desired password
which must be composed of 6 characters.
You can then conrm the password using the “En-
ter” button. Press the “Esc” button one or more
times to go back to previous menu levels or to exit
the menu.
ENERGY SAVING
The machine is programmed to be able to go into
energy saving mode after a certain time of inactiv-
ity. The preset value is 2 hours.
In Energy Saving mode the display on the machine
shows:
ENERGY SAVING
To bring the machine back to ready mode it is suf-
cient to press any selection button. By conrm-
ing the “Energy Saving” item with “Enter” you can
choose between the following two options by
pressing the 4 and 5 buttons:
➤ Energy saving deactivated
➤ Energy saving activated
You can choose to activate or deactivate Energy
Saving using the “Enter” button.
Press the “Esc” button one or more times to go back
to previous menu levels or to exit the menu.
START PUMPS
By conrming the “Start pumps” item with “Enter”
you can choose between the following two options
by pressing the 4 and 5 buttons:
➤ Start pumps activated
➤ Start pumps deactivated
You can choose to activate or deactivate the func-
tion using the “Enter” button.
Press the “Esc” button one or more times to go back
to previous menu levels or to exit the menu.
The start pumps function can be executed, in ma-
chine ready mode, by pressing buttons 3 and 6 at
the same time for at least 3 seconds.
Before activating the start pumps function
acuporglassmustrstbepositionedunder
thenozzle,onthecup-supportrack.
During start pumps the display will show the fol-
lowing message:
START
PUMPS IN PROGRESS
According to the result of the process and at the
end of it, the display will show the following mes-
sage.
START PUMPS
POSITIVE/NEGATIVE
When the machine is started for the rst time or af-
ter a prolonged period of not being used, it may be
necessary to rell the water system. The function, if
activated beforehand from the menu, is executed
automatically by the machine by pressing buttons
3 and 6 at the same time for at least 3 seconds.
CARD CHECK
This function allows the operator to check a chip
card, independently of its use. By conrming the
“Check card” item with “Enter” the display will show
the following message.
INSERT CARD