LAVAZZA LB 2801 - DISPENSING STEAM; PROGRAMMING; PROGRAMMING COFFEE SERVINGS

ENGLISH
71
5. PROGRAMMING
The programming operations must be carried out by trained and qualified
technical personnel.
5.1 PROGRAMMING COFFEE SERVINGS
• place the programming lever (1), located under the upper grille of the
machine, in the ON position;
• Insert a pod in the filter holder and attach it to the group, tightening
firmly;
• put the coffee cup under the dispensing spout;
• press the STOP/PROG button (2) for about 5 seconds; all the dose
button LEDs will come on;
• press the desired dose button(3);
• upon reaching the desired dose, confirm by pressing the STOP/PROG
key (2), or the key for the selection in programme;
• repeat this operation for the other dose button;
• when finished programming, return the programming lever (1) to the
OFF position.
4.5 DISPENSING STEAM
• Immerge the steam nozzle (6) in the liquid to be heated;
• turn the steam knob counter-clockwise (5);
• to interrupt steam dispensing turn the knob counter-clockwise
(5).
5
2
2
6
7
5
5
2
2
ON
1
ON
2
3 3
3 3
Carefully move the steam nozzle with the anti-burn
rubber (7), do not touch the hot water nozzle as
these are high temperature components.
Before using the steam to heat beverages or foam
milk, you must supply a steam vacuum until all
water leakage of consent.
The programming of each dose must be done with a new pod and not with previously used pods.