LAVAZZA LB 2801 - PROGRAMMING THE EXTRACTION OF HOT WATER

ENGLISH
72
5.2 PROGRAMMING THE EXTRACTION OF HOT WATER
• Regulate the temperature of the hot water which is fed out by
turning the water mixer cock (1) set up inside the back of the
machine. Turn the cock clockwise to diminish the volume of cold
water, and anticlockwise to increase the volume;
• set the programming lever (2) under the upper grill of the ma-
chine to the ON position;
• place the cup under the hot water faucet (3);
• press the STOP/PROG button (5) for about 5 seconds: all the
LEDs of the dose buttons will turn on;
• press the hot water button (4);
• once the required dose is obtained, confirm by pressing button
(4) again;
• press the STOP/PROG button (5);
• reset the programming lever (2) to the OFF position.
1
5
2
2
ON
2
ON
5
2
2
4
3
5