7
Rear Panel Connectors
The rear panel of the Z-100A features four connectors.
ANT: Connect the 50Ω coax antenna feedline to the standard SO-239 connector.
GND (wing nut): Connect to antenna system ground if needed.
RADIO: Connect the 50Ω coax jumper cable from this standard SO-239 connector to the
Antenna jack on the rear of the transceiver.
INTERFACE: This 6-pin mini-DIN connector connects to the radio interface cable. DC power
is also supplied via this connector. Be sure to turn off the transceiver before connecting or
removing cables.
To Next Page
