18
Event high Specify if a warning or an alarm will appear when
”Threshold high” is exceeded.
Disabled/
Warning/
Alarm
Threshold high Specify the measurement value at which an alarm
will appear when the value is exceeded.
Event low Specify if a warning or an alarm will appear when
”Threshold low” is exceeded.
Disabled/
Warning/
Alarm
Threshold low Specify the measurement value at which an alarm
will appear when the value is not attained.
Hysteresis Specify here how far the value will drop below the
Threshold high or go above the Threshold low before
an active warning is acknowledged automatically.
Output handling
AUX out active Indicates whether the AUX output is open or closed
when activated. If disabled, output will not be
activated during activities.
Disabled/
Open/
Closed
AUX out when Indicates if output will be activated when the device
is in Home or Away mode. Alternatively, you can set
the connection to activate in case of a warning or an
alarm.
Home/
Away/
Warning/
Alarm
Flow Test control
Specifies whether the relay output will be activated
on Flow Test alarm.
Enabled/
Disabled
Quick Test control
Specifies whether the relay output will be activated
on Quick Test alarm.
Enabled/
Disabled
Tightness Test
control
Specifies whether the relay output will be activated
on Tightness Test alarm.
Enabled/
Disabled
Volume Test
control
Specifies whether the relay output will be activated
on Volume Test alarm.
Enabled/
Disabled
RESTART
There are various ways to restart the screen:
• Through the menu. The text ”Restart” will be shown on the screen and the device
is restarted.
• By turning the device off and on again.
To Next Page
Loading...
