31
Additional Information
Wall Mount (Optional)
Items to purchase
You will need to purchase the following items separately to mount your Baby Unit:
2 screws
2 anchors
Notes:
• Check for reception strength and camera angle of the Baby Unit before drilling the holes.
• The types of screws and anchors you need depend on the composition of the wall.
1�
Use a pencil to mark two holes in parallel. Make sure they are the same
distance apart as the wall mount holes on the Baby Unit.
2�
Drill two holes in the wall (7/23 inch (5.5 mm) drill bit). If you drill the holes into
a stud, go to step 3.
-OR-
If you drill the holes into an object other than a stud, insert the wall anchors into
the holes. Tap gently on the ends with a hammer until the wall anchors are ush
with the wall.
To Next Page
Loading...
