6-4 Maintenance
d. Removal of the PCI Board
The PCI board removal procedure refers to the views of figure 8-5 and figure 8-9
Tools Needed:
• Diagonal cutting pliers
Procedure:
• Remove the upper cover assembly (6.2.1.a)
• Disconnect the two ribbon cables at J1 and J2 of the PCI card.
• Cut the cable clamp which secures the PCI card to the motherboard.
• Unplug the PCI card from the processor board.
e. Removal of the AGP-DVO Interface Board
The AGP-DVO removal procedure refers to the views of figure 8-5 and figure 8-9
Tools Needed:
• none
Procedure:
• Remove the upper cover assembly (6.2.1.a)
• Disconnect the video cable at J1 of the DVO Card.
• Disconnect the inverter power cable at J2.
• Bend the spring clamp on the AGP connector on the processor card slightly to
disengage the lock to the AGP/DVO card.
• Unplug the AGP/DVO card from the processor board.
f. Removal of the Processor Board
The processor board disassembly procedure refers to the views of figure 8-7 and
figure 8-9.
Tools Needed:
• #1 Philips screwdriver
Procedure:
• Remove the upper cover assembly (6.2.1.a)
• Remove the PCI card (6.2.1.d)
• Remove the AGP/DVI Interface (6.2.1.e).
• Disconnect the following cables on the processor board:
Processor Connector Connects to
Primary IDE Hard Drive
Secondary IDE CD ROM drive
Main Power Power supply harness
Supplemental Processor Power Power supply harness
Front Panel USB USB Hub & Acq Board
Front Panel Header Power Switch – Acq Board
To Next Page
Loading...
