6-22 Maintenance
6.4 Board Exchange Procedure
6.4.1 Processor Board Exchange Procedure
The WaveRunner 6000 system may be built with different processor configurations
as the WaveRunner 6000 series uses an Intel motherboard. Currently the units are
built with 1.8Ghz Celerons. Different hard disk images must be loaded based on the
type of processor board installed. Only use the System Recovery CD which was
delivered with your WaveRunner 6000.
6.4.2 Hard Drive Replacement Procedure
The Hard Drive contains important calibration files which must be restored if the hard
drive is to be completely erased or replaced. (see section 6.6 for instructions)
Please note: if the hard drive is restored using the System Recovery CD which is
supplied with the WaveRunner these files will not be damaged or removed.
To Next Page
Loading...
