Specifications 3-3
WaveRunner WaveRunner WaveRunner WaveRunner WaveRunner
6030(A) 6050(A) 6051(A) 6100(A) 6200(A)
Trig Sensitivity
(Edge Trigger)
2 div@350 MHz 2 div@500 MHz 2 div@500 MHz 2 div@1 GHz 2 div@2 GHz
CH 1-4 + ext 1 div@250 MHz 1 div@350 MHz 1 div@350 MHz 1 div@750 MHz 1 div@1.8 GHz
Max Trig Freq
with SMART
Trigger®
350 MHz 500 MHz 500 MHz 750 MHz 750 MHz
CH 1-4 + ext @ ≥ 10mV @ ≥ 10mV @ ≥ 10mV @ ≥ 10mV @ ≥ 10mV
Trigger Level DC
Accuracy
±4% full scale ±2mV (typical)
External trigger range EXT/10 ±4V; EXT ±400mV
3.6 Basic Triggers
Edge/Slope/Line
Triggers when signal meets slope (positive or negative) and level
condition
3.7 SMART Triggers®
State or Edge Qualified
Triggers on any input source only if a defined state or edge occurred
on another input source .
Delay between sources is selectable by time or events.
Dropout
Triggers if signal drops out for longer than selected time between 2 ns
and 20 s.
Pattern
Logic combination (AND, NAND, OR, NOR) of 5 inputs (4 channels
and external trigger input - 2ch+EXT on 6051). Each source can be
high, low, or don't care.
The high and low level can be selected independently. Triggers at start
or end of the pattern.
3.8 SMART Triggers® with Exclusion Technology
Glitch & Pulse Width
Triggers on positive or negative glitches with widths selectable from 600 ps
to 20 s or on intermittent faults. (Subject to bandwidth limit of oscilloscope).
Signal or Pattern Width
Triggers on positive or negative pulse widths selectable from 600 ps to 20 s
or on intermittent faults. (Subject to bandwidth limit of oscilloscope).
Signal or Pattern Interval Triggers on intervals selectable between 2 ns and 20 s.
Timeout (State/Edge
Qualified)
Triggers on any source if a given state (or transition edge) has occurred on
another source.
Delay between sources is 10ns to 20 s, or 1 to 99,999,999 events.
Exclusion Triggering Trigger on intermittent faults by specifying the normal width or period.
Automatic Setup
Auto Setup Automatically sets timebase, trigger, and sensitivity to display a wide range
Vertical Find Scale
Automatically sets the vertical sensitivity and offset for the selected channels
to display
3.9 Probes
Probes
One PP007 per channel standard; Optional passive and active probes
available
Probe System; Probus Automatically detects and supports a variety of compatible probes
Scale Factors Automatically or manually selected, depending on probe used
To Next Page
Loading...
