DSR4
LECTROSONICS, INC.
16
Firmware Update
Instructions
Firmware updates are made through Wireless Desiger,
with a le downloaded from the web site and the DSR4
connected via USB. The USB port on the receiver re-
quires a micro-B male plug on the connecting cable. The
other end of the cable would normally be a USB A-Type
male connector to t the most common type of USB jack
used on computers.
Be aware of the following when preparing to connect
your DSR4 to Wireless Designer via USB:
The DSR4 must have the micro and FPGA rmware both
updated to v1.01 or higher. Wireless Designer version
must be at least 2.0.39 for macOS, or version 2.0.42 or
higher for Windows. These are available on our Support
website at: https://lectrosonics.com/support.html.
Refer to Help in Wireless Designer software for the up-
date procedure.
NOTE: If your Wireless Designer does not
“recognize” the DSR4 and you are using the
most updated version, your USB drivers may
need to be updated. This is not a procedure that
needs to be done often. You can find a folder
with the most updated drivers on the Wireless
Designer section of our Support page.
To Next Page
Loading...
