lefant LS1 - 2. Preparation; 2.1 Assemble and Charge

10
2. Preparation / 2.1 Assemble and charge
Place the robot at Docking Station and make sure
to align the charging electrodes
* Place the docking station on an open place.
* Connect the power supply and tidy up the power
cord to avoid twining.
Placement of the charging base /
connection of power supply
Turn on the robot
Reminder: Cannot charge when
product is turned off.
Charging
Remove the protective film on the robot
and docking station
Install the side brushes
>1.5m
(4.92’)
>0.5m
(1.64’)
>0.5m
(1.64’)
twinkling means charging.
turn off means fully charged.
A full charge takes 7-8 hours.
“ I ”means ON , “ O ”means OFF
Click