LEGRAND KEOR HPE UPS - Page 44

Installation and start-up of KEOR HPE UPS 60÷160 kVA
Installation et démarrage de l’ASI KEOR HPE 60÷160 kVA
Installazione e avviamento KEOR HPE UPS 60÷160 kVA
44 OML46086 REV. C
 RS232/USB: it is used for connection to the proprietary programming and control
software.
 SRC-2 (OPTIONAL): relay card, used for the remote signalisations of status and alarms.
 PARALLEL (OPTIONAL): it is used for communication between paralleled UPS units.
 MODBUS (OPTIONAL): it is used for the transmission of data to the outside via MODBUS
RTU protocol (RS485).
 THERMAL PROBE (OPTION): it is used to acquire the temperature of the battery
cabinet/room in order to adjust the charging voltage automatically.
 SNMP (OPTIONAL): it is used for the external transmission of data via LAN.
 NORMAL/BYPASS SELECTOR