• This UPS utilizes voltages that may be hazardous.
Do not attempt to disassemble the unit. The unit
contains no user serviceable parts. Only factory
service personnel may perform repairs.
• Connection to any other type of receptacle other than
a 2-pole, 3-wire grounding receptacle may result in
shock hazard as well as violate local electrical codes.
• In the event of an emergency, turn the power switch to
the “off” position and disconnect the power cord from
the AC power supply to properly disable the UPS
• Do not allow any liquids or any foreign object to enter
the UPS. Do not place beverages or any other
liquid-containing vessels on or near the unit.
• This unit is intended for installation in a controlled
environment (temperature controlled, indoor area free
of conductive contaminants). Avoid installing the UPS
in locations where there is standing or running water,
or excessive humidity.
• Do not plug the UPS input into its own output.
• Do not attach a power strip or surge suppressor to
the UPS.
• Do not attach non-computer related items, such as
medical equipment, life-support equipment, microwave
ovens, or vacuum cleaners to UPS.
• To reduce the risk of overheating the UPS, do not cover
the UPS’ cooling vents and avoid exposing the unit to
direct sunlight or installing the unit near heat emitting
appliances such as space heaters or furnaces.
• Unplug the UPS prior to cleaning and do not use liquid
or spray detergent.
• Do not dispose off battery or throw batteries in a fire.
The battery may explode.
• Do not open or mutilate the battery or batteries.
Released electrolyte is harmful to the skin and eyes.
It may be toxic.
• A battery can present a risk of electrical shock and high
short circuit current. The following precautions should
be observed when working on batteries:
1) Remove watches, rings, or other metal objects from
the hand.
2) Use tools with insulated handles.
3) Wear rubber gloves and boots.
4) Do not lay tools or metal parts on the top of batteries.
5) Disconnect charging source prior to connecting or
disconnecting batteries terminal.
• Servicing of batteries should be performed or
supervised by personnel knowledgeable of batteries
and the required precautions. Keep unauthorized
personnel away from batteries.
• When replacing batteries, replace with the same type
and number of the sealed lead-acid batteries. The
maximum ambient temperature rating is 40
0
c.
• This pluggable type-A equipment with battery already
installed by the supplier is operator installable and
may be operated by laymen.
• During the installation of this equipment it should be
assured that the sum of the leakage currents of the
UPS and the connected loads does not exceed 3.5 mA.
•
Beware of hazards that may arise through electric
shocks. Also, while disconnecting this unit from the
mains, may be available through. supply from battery.
The battery supply should be therefore disconnected
in the plus and minus pole of the battery when
maintenance or service work inside the UPS is necessary.
• The mains socket outlet that supplies to the UPS shall
be installed near the UPS and shall be easily accessible.
Disclaimer
• The contents of this manual are bound to change without prior notice.
• We have exercised reasonable care to give you an error-free manual. Numeric disclaims liability for any inaccuracies
or omissions that may have occurred. If you find information in this manual that is incorrect, misleading or incomplete,
we would appreciate your comments and suggestions.
• Before you begin the installation of the product, please read this manual thoroughly. The warranty
of this product is null and void, if the product is abused/misused.
Save these instructions: This manual contains important instructions for the model Digital 600 EX V that should be
followed during installation and maintenance of the UPS and batteries.
IMPORTANT SAFETY INSTRUCTIONS
To Next Page
Loading...
