Leica BLK2GO - User Interface; Power Button Functions

3 User Interface
3.1 Power Button
19556_001
a
a Power button
Power button when the BLK2GO is THEN
Press and hold the
button < 2 sec.
off. The BLK2GO switches on
and the LED starts blink-
ing yellow.
Press and hold the
button < 2 sec.
on and ready. The LED is
continuous green.
The BLK2GO starts ini-
tialising and the LED
starts blinking yellow.
Press and hold the
button < 2 sec.
in recording mode. The BLK2GO is taking a
picture with the detail
camera.
Press and hold the
button ≥ 2 sec.
< 5 sec.
in recording mode. The BLK2GO stops
recording and gets into
idle state. The LED is
continuous green.
Press and hold the
button ≥ 2 sec.
< 5 sec.
on and ready. The LED is
continuous green.
The BLK2GO switches
off.
Press and hold the
button < 2 sec.
in recording mode. The
LED is continuous yellow.
Data recording is inter-
rupted due to a failure.
The BLK2GO gets into
idle state.
Press and hold the
button ≥ 5 sec.
on. The BLK2GO switches off
immediately. Hard shut-
down.
NOTICE
It is mandatory to follow always this procedure to shut down the instrument.
Do not remove the battery from a running instrument!
Power button
18 User Interface