47
Leica IP C
Instrument Setup 4
3. Used or new transport cartridge:
Caution
NEVER press CLEAN while an ink cartridge is in the instrument! The entire contents of the ink
cartridge will spill into the printer.
» Press the key CLEAN; the current ink level is stored.
Note
The fill level of the transport cartridge is not monitored. Each use should be noted on the cartridge.
The cartridge can be used twice. The cycle time when inserting a transport cartridge is 3.5 minutes
and is thus considerably longer than that of an ink cartridge.
• After one of the three buttons has been pressed, the ink exchange software routine starts; air is
evacuated from the hoses and the system is refilled with liquid.
When the procedure has been completed, 88 disappears from the display.
Running a test print
L Run a test print to verify whether the print head works correctly.
1. For that purpose, fill some cassettes into a magazine and insert the magazine into magazine
position 1.
2. Press and hold the CLEAN button until "00" is displayed, then release the button. A cassette is
imprinted with a stored test image.
If the print result is not satisfactory, this step can be repeated several times.
To Next Page
Loading...
