How to fix a low battery indication on my Leica Laser Level display?
If you see the Low Battery indication on the display of your Leica laser level, it means the batteries are low. Replace the alkaline batteries or recharge the Li-Ion battery pack.
Why is the 'empty battery' icon flashing on my Leica Rugby 880 Laser Level?
If the Leica Rugby laser level has reached a low battery condition, the “empty battery” icon will flash. Check the battery of the Rugby.
How to fix a Leica Laser Level Rugby that does not turn on?
If the Rugby does not turn on, it may be because the batteries are low or dead. Check the batteries and change or charge them if necessary.
What to do if semi-automatic calibration does not work on my Leica Laser Level?
If the Semi-automatic Calibration procedure could not be completed on your Leica Laser Level, repeat the procedure.
What to do if the Servo Limit Alert screen is shown on my Leica Rugby 880 Laser Level?
If the Leica Rugby laser level is tipped too far, it cannot reach a level position. Relevel the Rugby within the 6 degree self-levelling range.
Why is my Leica Laser Level Rugby not communicating with the RC800 remote control?
If the Leica Rugby laser level has lost the communication link to the remote control, ensure that you are within clear sight of the Rugby and that you have not exceeded the 100 m (300’) working range.
What to do if the Elevation (H.I.) Alert screen is shown on my Leica Laser Level?
If the Elevation (H.I.) Alert screen is shown and the audio beeps on your Leica Rugby laser level, it means the device has been bumped or the tripod was moved. Turn off the device to stop the alert, then check the height of the laser before beginning to work again. Allow the device to relevel and check the height of the laser.
What should I do if the Temperature Alert screen is shown on my Leica Rugby 880 Laser Level?
If the Leica Rugby laser level is in an environment where it cannot operate without damaging the laser diode, the Temperature Alert screen will appear. Shade the Rugby from the sun.
Why is the laser distance reduced on my Leica Laser Level?
The distance of the laser is reduced because dirt is reducing the laser output. Clean the windows of the Rugby and the receiver.
Why is my Leica Laser Level receiver not working properly?
If the Leica laser receiver is not working properly, it may be because the Rugby is not rotating, is levelling, or is in H.I. Alert. Check for proper operation of the Rugby. Another reason may be that the receiver is out of usable range, so move closer to the Rugby. Also, the batteries of the receiver may be low, so check the low battery symbol on the receiver display and change the receiver batteries.
General| Type | Rotary Laser Level |
|---|---|
| IP Rating | IP68 |
| Operating Time | up to 40 hours |
| Laser Class | Class 2 |
| Laser Wavelength | 635 nm |
| Accuracy | ±1.5 mm at 30 m |
| Power Supply | Rechargeable Li-Ion battery pack |
| Operating Temperature | -20°C to +50°C |
To Next Page
