Single Pass
Half-Blind Dovetails
D4R Pro - CHAPTER 11
Why rout “single pass” dovetails on a variable spaced Leigh jig? Well, you just may need to reproduce or restore a
late 19th or early 20th century drawer which has similar, machine made joints. Or, if you are making a lot of drawer
boxes and are not so concerned with the traditional “hand cut look”, then routing both drawer fronts and sides
together does go a little faster.
MODE ICONS
Illustrations in this user
guide include the correct
mode icon for the cur-
rent instruction. The
icons are also used in
the instruction text.
Only one mode is required:
Half-Blind Dovetail Tails (HB TAILS) mode
1
Inches Millimeters
39
Active
Guide Surfaces
Spacer
The online video will reduce your learning time
dramatically!
Stream to your smart phone or tablet to use in
your shop as a visual reference. Find the video in the Instructional
Videos section of the Support menu at leighjigs.com.
Watch the Online Instructional Video
To Next Page
Loading...
