Leister DRIVE - Conformity; Disposal; Technical data

12
Technical data
Leister Technologies AG, Galileo-Strasse 10, CH-6056 Kaegiswil/Switzerland
confirms that this product, in the version as brought into circulation through us, fulfils
the requirements of the following EC directives.
Directives: 2006/42, 2004/108, 2011/65
Harmonised standards: EN 12100-1, EN 12100-2, EN 14121-1
EN 55014-1, EN 55014-2, EN 62233
EN 6100-3-2, EN 6100-3-3, EN 60335-2-45, EN 50581
Kaegiswil, 10.04.2013
Bruno von Wyl, CTO Beat Mettler, COO
Power tools, accessories and packaging should be sorted for environmental-
friendly recycling. Only for EC countries: Do not dispose of power tools into
household waste! According to the European Directive 2002/96 on waste
electrical and electronic equipment and its incorporation into national law,
power tools that are no longer suitable for use must be separately collected
and sent for recovery in an environmental-friendly manner.
Disposal
Conformity
Type DRIVE
Voltage V~ 230 120
Power consumption W 100 100
Frequency Hz 50/60
Drive speed m/min. 0.5 – 3 stepless
Dimensions mm 250 × 165 × 88, handle ø 63
Weight kg 2.3 with 3 m power supply cord
Mark of conformity 2
Approval mark 3
Certification scheme CCA
Protection class I 1
Mains voltage cannot be switched over !
For hot air blower technical data, refer to the TRIAC AT or TRIAC ST operating
instructions !
Technical data and specifications are subject to change without prior notice
128.715_DRIVE__D_GB_F_E_I_NL_S_Deutsch_TriacDrive.qxd 11.07.13 08:05 Seite 12