LEITZ LABORLUX S - Polarization Microscopy

Polarisation
Remove the protection piece fr om the analyser slit (18.1) and
push
the slide with the analyser (18.2) into the slit (18.1).
In sert the filter holder into the field diaphragm mount so that
the open part faces the user. It should click into place.
Push
the polariser (1) into the low er slit of the filter holder and
turn until the field of view, observed without a spec im en in
place, appears at its darkes t.
If desired, a compensator ( ,\ or Al4 plate) (19. 2) can be used in
th e sec on d filter slit above th e polarise r.
Fig. 18 Inserting the analyser
Fig.
19 A rrangeme nt or the poiariser
I Polariser
2 Compensator
3 Holder
17