Operating Instructions 5-1
D-H021.1011EN
innovators in agriculture
5. OPERATING INSTRUCTIONS
5.1 Transport the SHUTTLE
WARNING
Always lock the cover when sample bottles are in the SHUTTLE.
CAUTION
- Make sure the transport handle is fully in when you do not transport the
SHUTTLE.
- Do not transport the SHUTTLE with filled sample bottles installed.
1. Make sure:
• The milk tubes, fill head and level sensor are clean.
• The CAN-bus cable is disconnected from the milking robot and
wound on the cable bracket (2)
• The bleed tube strip (3) is down
• The milk tube is disconnected from the milk tube connection
• The cover is closed.
2. Pull out the transport handle (1).
3. Use the transport handle to lift the SHUTTLE.
Figure 6. Transport the SHUTTLE
To Next Page
Loading...