Troubleshooting 8-5
D-H021.1011EN
innovators in agriculture
Code Description Result Reason Action
The spindle is dirty Clean the spindle with a
clean, soft towel
If the alarm remains, call
your local service provider
The movement of the fill
head is obstructed
Make sure the fill head
can move freely
C Electrical current
required by the X-
axis and/or Y-axis
motor is too high
The sampling
process will
continue as
normal
The milk time of the
milked cow is too short
No milk sample is taken
during this milking. The
next time the cow is
milked a new attempt is
made
8.3 Reset an Alarm
1. Push the button [STOP/RESET] for a short time..
2. Make sure the alarm code disappears and the dot starts blinking.
3. Make sure the buzzer stops.
8.4 Reset the SHUTTLE
CAUTION
All actions are stopped when you do this procedure.
1. Push and hold button [STOP/RESET] for more than 5 s.
2. Make sure the SHUTTLE resets and the fill head moves to the home
position.
To Next Page
Loading...