Troubleshooting 8-1
D-H021.1011EN
innovators in agriculture
8. TROUBLESHOOTING
8.1 Attention Codes
The table shows the attention codes. The attention codes are only visible
for a few seconds. The attention codes, plus the time when they
appeared, are stored in the SHUTTLE and can be read with the E-Link
controller for service.
Code Description Result Reason Action
The milk tube is not
connected (correctly)
Examine the milk tube
and the milk tube
connections
The sampling cylinder
does not work correctly
Examine the sampling
cylinder
A
The bottle could
not be filled
within 60 s after
the fill command
A time-out is
generated.
The sampling
process will
continue as
normal
The SHUTTLE is not
positioned correctly
Make sure the position
and the height of the
SHUTTLE is correct. See.
The lid of the bottle to
be filled is not fully open
The lid must be between
the casings. See .
The bottle to be filled is
not installed correctly
Make sure the bottle is
correctly installed
The rack is not straight
or bent
Replace the rack with a
straight one
b The fill head could
not move down
(Z-axis) or could
not reach the
lowest position
The sampling
process will
continue as
normal
The cover of the
SHUTTLE is not closed
correctly
Make sure the cover is
correctly closed.
The spindle is dirty Clean the spindle with a
clean, soft towel
If the attention remains,
call your local service
provider
The movement of the fill
head is obstructed
Make sure the fill head
can move freely
d The fill head did
not reach the
requested bottle
before the fill
command was
given
The sampling
process will
continue as
normal
The milk time of the
milked cow is too short
No milk sample is taken
during this milking. The
next time the cow is
milked a new attempt is
made
To Next Page
Loading...