6-2 Maintenance
D-H021.1011EN
innovators in agriculture
6. Clean the fill head (4), the valve on the fill head (inside and
outside) and the level sensors (5) with the brush (6).
2. Repeat flushing and cleaning procedure with warm water and the
alkaline cleaning agent.
3. Repeat flushing and cleaning procedure with clean, cold water.
4. Repeat flushing and cleaning procedure with clean, cold water to
make sure all of the cleaning agent is removed.
Clean the case
CAUTION
Make sure you do not wet the spindles and electrical parts.
1. Carefully clean the outside and the inside of the SHUTTLE with a
sponge and cold or luke warm water.
Close-up
1. Install the syringe on its bracket in the SHUTTLE.
2. Install the sample box in the SHUTTLE.
3. Install the racks.
4. Close the cover and fasteners.
Figure 13. Clean the milk tube, bleed tube, inner parts and fill head
To Next Page
Loading...