innovators in agriculture
EN-19
7.5 Changing oil in gearboxes
Change the oil in the gearboxes or drive element of a new mower
(or after assembly of a new gearbox) for the first time after
approximately 30 working hours, and every 250 working hours
thereafter.
- Place a collection container underneath the gearbox.
- Unscrew the drain plug (arrow, fig. 26 or 27) from the gearbox
and allow the oil to flow into the collection container.
- Fill the gearbox A (fig. 26) with 1.7 l of GX85-W140 transmission
oil.
- Fill the gearbox B (fig. 27) with 0.85 l of GX85-W140 transmission
oil.
- Remove the skid in order to gain access to the drain/filling plug.
Tilt the cutter bar slightly backwards to remove the oil. Tilt the
cutter bar forward to fill the drive element.
- Fill the drive element C with a carefully measured quantity of
0.45 l of GX85W-140 transmission oil.
An incorrect quantity could make the gearbox and/or drive
element overheat, causing irreparable damage.
Change the oil more frequently when operating the machine
in extreme working conditions.
To Next Page
Loading...
