Adjustments
69
9.13 Levelling beam
CAUTION
Before adjusting the levelling beam, always move the side blade
into the working position.
The circular spike harrow can be equipped at the rear or front with a levelling
beam (1).
9.13.1 Rear-mounted levelling beam
Set the levelling beam (1) using the rough-
turning gauge (2) so that the lower edge of
the levelling beam is about 2 cm over the
surface of the ground!
If too much soil is banked up, set the level-
ling beam slightly higher!
To adjust the height remove the locking
pin (3).
Then use the wrench included, to adjust
the height of the levelling beam.
Mount the locking pin (3).
9.13.2 Forward-mounted levelling beam
The levelling beam should be set low enough to ensure that a slight wall is formed
in the middle. This guarantees an excellent lateral distribution and levelling of the
ground.
2
3
To Next Page
